Jiefang CA-30 King Kong 6x6 (Zil 157)

[FREEDOM83]

both sides of everything painted, I only lack the body on the outside







And the tipper has already arrived... first set, a bit long?



Then I have removed the front tie-down and the rear wheel arch and it seems that raising it a bit looks better (just what I needed to put everything on top of the chassis spars and be able to remove and put it)


how long do you see it?

[FREEDOM83]

It is indeed a bit long. You could consider to make the bucked a little shorter, here they normally end just behind the last back wheel.

[FREEDOM83]

It is indeed a bit long. You could consider to make the bucked a little shorter, here they normally end just behind the last back wheel.

Depends on what you're comparing it to, i think it's not so long









It's to be used at a friend's house, I'm not going to exhibitions, plus the tipper system will go on a platform that can be easily removed and put on to do some route with the truck, & I also want to make a box for wood , to have more options

[FREEDOM83]

Hard work this weekend :






testing tipper

[FREEDOM83]

Last test, from below with a lot of weight it is difficult to start due to the position, but it is the best place, the kipper did not rise so much vertically on the sides and they were very outside, so in the end I will have to design some rear fenders of some kind hehehehe mode

[youtube]YmY78h21Oew[/youtube]

[FREEDOM83]

Yesterday I already set it up from the transmitter, today I'll get with the microswitches for the cut stroke when lowering and then paint the bracket and motors.

[youtube]HfeCAvZ0ihE[/youtube]

[FREEDOM83]

two details are missing but it's ready

[FREEDOM83]

A video of the only test, for now I have to put it up for sale out of necessity:



[youtube]XNvL6Awk3JU[/youtube]

[FREEDOM83]

Nice project, well done

[JurjenF]